The Recreational Vehicle Industry Association (RVIA) is pushing a proposal through the U.S. Congress to change the definition of manufactured home in the National Manufactured Home Construction and Safety Standards Act. The proposed change would specifically exclude certain “RV trailers,” including Park Model RVs, from the definition of a manufactured home in the federal HUD Code.
The stated purpose of the proposed change is to provide regulatory certainty to lenders, state or local taxation and land use officials that a Park Model RV is a recreational vehicle, not a manufactured home.
Their urgency for this change is that some lenders are apprehensive about making Park Model RV loans in light of the new Dodd-Frank Act requirements.
A concern with the language, as proposed, is that it may allow ANSI Park Model RVs to expand beyond the current 400 square foot size limitation.
This would be harmful to the HUD-Code RV Park Model industry in states like Florida by encouraging the sale of ANSI Park Models that exceed 400 square feet.
The proposed amendment states, “a park model RV that has a gross area not greater than 400 square feet based on the exterior dimensions of the unit measured at the largest horizontal projections in the set-up mode, including all floor space that has a ceiling height of more than 5 feet” (emphasis added).
The ceiling height language was inserted to codify a 1997 HUD interpretation that loft areas which are less than 5’0” in height are not considered in determining the size of the structure. The proposed language does not limit the ceiling height exclusion to loft areas, thus allowing for the possibility of “slide-out rooms” or “build-outs” less than 5 feet high.
RVIA is emphatic that the intent is not to increase the size of ANSI Park Model RVs.
According to RVIA, concerns about enlarging the size of Park Model RVs are unfounded because specific rules are in place to measure the size and calculate the square footage of Park Model RVs. Additionally, Park Model RVs are built to standards administered by the American National Standards Institute (ANSI), a national voluntary consensus body. The ANSI A119.5 standards would have to be amended to allow for larger structures.
While these safeguards are in place today, the statute will drive future requirements. If the federal law is ambiguous enough to assert that larger ANSI RV Park Models are allowed, then the rules will change to accommodate this view.
The RVIA is working hard to get this amendment accomplished during the 2015 HUD appropriations process. RVIA is not looking for industry support, but rather seeks to quell any opposition.
MHI has taken a neutral position on the proposal, while MHARR is adamantly opposed to it.
This proposed change to the National Manufactured Home Construction and Safety Standards Act will have a negative impact on the HUD-Code Park Model industry in Florida. Most Park Models are permanently sited and larger ANSI Park Model RVs will encourage permanent, year round living. ANSI Park Model RVs are designed and intended for recreational use and seasonal living only and are not built to the more stringent HUD building code.
The Florida Manufactured Housing Association (FMHA) has asked RVIA to consider amending its proposal to specify that the 5 foot ceiling height exemption applies to loft areas only. This will ensure that ANSI Park Model RVs are not built in excess of 400 square feet.
Reasserting the current size restriction in the proposed amendment will satisfy the RV industry’s objective of clarifying the differences between ANSI Park Model RVs and HUD manufactured homes for financing and land use purposes, while promoting ANSI Park Model RVs as a desirable option for recreational and seasonal accommodations. ##
James R. Ayotte, CAE
Executive Director
Florida Manufactured Housing Association
3606 Maclay Blvd. South – Suite 200
Tallahassee, FL 32312
Ph:(850) 907-9111
F:850) 907-9119
jayotte@fmha.org
www.fmha.org
